Cisco Cisco Packet Data Gateway (PDG)
BITS Port Configuration Mode Commands
snmp trap link-status ▀
Command Line Interface Reference, StarOS Release 16 ▄
1639
snmp trap link-status
Enables/disables the generation and sending of an SNMP (notification) trap when the port experiences a change of state
(up or down).
(up or down).
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > BITS Port Configuration
configure > port bits slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
[ no ] snmp trap link-status
no
Disables the sending of traps for link-status changes.
Usage
Enable the sending of link-status change traps if there is a monitoring facility that can use the information or
if there are troubleshooting activities in progress.
if there are troubleshooting activities in progress.
Example
Use this command to enable sending of link-status SNMP traps:
snmp trap link-status
Use this command to disable sending of link-status SNMP traps:
no snmp trap link-status