Cisco Cisco Packet Data Gateway (PDG)
Credit Control Configuration Mode Commands
diameter ignore-service-id ▀
Command Line Interface Reference, StarOS Release 16 ▄
2731
diameter ignore-service-id
This command enables to accept/ignore service ID in the Service-Identifier AVP defined in the Diameter dictionaries.
This command is applicable to all products that use the Gy interface.
This command is applicable to all products that use the Gy interface.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Credit Control Configuration
active-charging service service_name > credit-control
Entering the above command sequence results in the following prompt:
[local]host_name(config-dcca)#
Syntax
[ default | no ] diameter ignore-service-id
default
Configures this command with the default setting.
Default: Accept
Default: Accept
no
Specifies to accepts the service ID.
Usage
Use this command to ignore/accept service ID value in the Service-Identifier AVP in the Diameter
dictionaries for Gy interface implementations.
This command can be used to disable the usage of the Service-Identifier AVP for Gy interface
implementations even if any of the Diameter dictionaries support the Service-Identifier AVP, and if this AVP
should not be used for Gy interactions but must be present in GCDRs/eGCDRs.
dictionaries for Gy interface implementations.
This command can be used to disable the usage of the Service-Identifier AVP for Gy interface
implementations even if any of the Diameter dictionaries support the Service-Identifier AVP, and if this AVP
should not be used for Gy interactions but must be present in GCDRs/eGCDRs.
Example
The following command specifies to ignore service ID in the Diameter dictionaries:
diameter ignore-service-id