Cisco Cisco Packet Data Gateway (PDG)
Firewall-and-NAT Access Ruledef Configuration Mode Commands
ip dst-address ▀
Command Line Interface Reference, StarOS Release 16 ▄
5023
ip dst-address
This command configures an access ruledef to analyze user traffic based on IP destination address.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Access Ruledef Configuration
active-charging service service_name > access-ruledef access_ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-fw-ruledef)#
Syntax
[ no ] ip dst-address { operator { ipv4/ipv6_address | ipv4/ipv6_address/mask } | {
!range | range } host-pool host_pool }
!range | range } host-pool host_pool }
no
Removes previously configured IP destination address ruledef.
operator { ipv4/ipv6_address | ipv4/ipv6_address/mask }
operator
specifies how to logically match the IP destination address.
operator
must be one of the following:
!=
: Does not equal
<=
: Less than or equals
=
: Equals
>=
: Greater than or equals
ipv4/ipv6_address
: Specifies the IP address of destination node for outgoing traffic.
ipv4/ipv6_address
must be the IP address entered using IPv4 dotted-decimal notation or IPv6 colon-
separated-hexadecimal notation.
ipv4/ipv6_address/mask
: Specifies the IP address of destination node for outgoing traffic.
ipv4/ipv6_address/mask
must be the IP address entered using IPv4 dotted-decimal notation or IPv6
colon-separated-hexadecimal notation. The mask bit is a numeric value which is the number of bits in the
subnet mask.
subnet mask.
{ !range | range } host-pool host_pool }
!range | range
: Specifies the range criteria:
!range
: Not in the range of
range
: In the range of
host-pool host_pool
: Specifies the host pool name.
host_pool
must be an alphanumeric string of 1
through 63 characters.