Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (T-threshold phspc)
threshold aaa-auth-failure-rate ▀
Command Line Interface Reference, StarOS Release 16 ▄
5451
threshold aaa-auth-failure-rate
Configures authentication failure rate, alarm or alert thresholds for the system.
Product
PDSN
GGSN
HA
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold aaa-auth-failure-rate high_thresh [ clear low_thresh ]
default threshold aaa-auth-failure-rate
high_thresh
Default: 5
Specifies the high threshold percent of authentication failures that must be met or exceeded within the polling
interval to generate an alert or alarm.
Specifies the high threshold percent of authentication failures that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 100.
clear
Allows the configuration of Specifies the low threshold.
low_thresh
Default: 5
Specifies the low threshold percent of authentication failures that maintains a previously generated alarm
condition. If the percentage of failures falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
Specifies the low threshold percent of authentication failures that maintains a previously generated alarm
condition. If the percentage of failures falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
low_thresh
is an integer from 0 through 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.