Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (T-threshold phspc)
threshold asngw-max-eap-retry ▀
Command Line Interface Reference, StarOS Release 16 ▄
5461
threshold asngw-max-eap-retry
Configures alarm or alert thresholds for maximum retries for Extensible Authentication Protocol (EAP) authentication
within an ASN-GW service.
within an ASN-GW service.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold asngw-max-eap-retry high_thresh [ clear low_thresh ]
default threshold asngw-max-eap-retry
high_thresh
Default: 0
Specifies the high threshold number of retries for EAP authentication that must be met or exceeded within the
polling interval to generate an alert or alarm.
Specifies the high threshold number of retries for EAP authentication that must be met or exceeded within the
polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of retries for EAP authentication that maintains a previously generated
alarm condition. If the number of retries falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
Specifies the low threshold number of retries for EAP authentication that maintains a previously generated
alarm condition. If the number of retries falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
low_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set threshold limits to generate alerts or alarms based on the number of retries for EAP
authentication that occur during the specified polling interval.
Alerts or alarms are triggered for maximum number of retries for EAP authentication based on the following
rules:
authentication that occur during the specified polling interval.
Alerts or alarms are triggered for maximum number of retries for EAP authentication based on the following
rules:
Enter condition: Actual number of failures is greater than or equal to the high threshold.
Clear condition: Actual number of failures is less than the low threshold.