Cisco Cisco Packet Data Gateway (PDG)
GTP-U Service Configuration Mode Commands
▀ echo-interval
▄ Command Line Interface Reference, StarOS Release 16
6032
echo-interval
Configures the rate at which GPRS Tunneling Protocol (GTP) v1-U echo packets are sent.
Product
ePDG
GGSN
P-GW
SAEGW
SGSN
S-GW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > GTP-U Service Configuration
configure > context context_name > gtpu-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-gtpu-service)#
Syntax
echo-interval seconds [ dynamic [ smooth-factor multiplier ] ]
{ default | no } echo-interval
default
Disables the configured echo-interval setting.
no
Removes the configured echo-interval setting.
seconds
Specifies the number of seconds between the sending of a GTP-Uv1 echo packet.
seconds
must be an
integer from 60 through 3600. Default: 60
dynamic [ smooth-factor multiplier ]
Enables the dynamic echo timer for the GTP-U service.
smooth-factor multiplier
: Introduces a multiplier into the dynamic echo timer as an integer from 1
through 5. Default: 2
Usage
Use this command to configure the rate at which GTP-Uv1 echo packets are sent.
Example