Cisco Cisco Packet Data Gateway (PDG)
IuPS Service Configuration Mode Commands
gtpu ▀
Command Line Interface Reference, StarOS Release 16 ▄
6643
gtpu
This commands configures parameters for the GTP user (GTP-U) dataplane.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IuPS Service Configuration
configure > context context_name > iups-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-iups-service)#
Syntax
gtpu { bind ip_addr | echo-interval seconds | max-retransmissions number |
retransmission-timeout seconds | sync-echo-with-peer }
retransmission-timeout seconds | sync-echo-with-peer }
no gtpu { bind address ip_addr | echo-interval | max-retransmissions | retransmission-
timeout | sync-echo-with-peer }
timeout | sync-echo-with-peer }
default gtpu { echo-interval | max-retransmissions | retransmission-timeout | sync-echo-
with-peer }
with-peer }
no
Removes the configured parameter value.
default
Sets the specified parameter to its default setting.
bind address ip_addr
This command binds the specified IP address to the Iu-PS GTP-U endpoint.
ip_addr
: Must be an IP v4 IP address in dotted decimal notation.
echo-interval seconds
Default: 60
Configures the rate, in seconds, at which GTP-U echo packets are sent to the UTRAN over the Iu-PS
interface.
Configures the rate, in seconds, at which GTP-U echo packets are sent to the UTRAN over the Iu-PS
interface.
seconds
: Must be an integer from 60 through 3600.
max-retransmissions number
Default: 5
Configures the maximum number of transmission retries for GTP-U packets.
Configures the maximum number of transmission retries for GTP-U packets.
number
: Must be an integer from 0 through 15.