Cisco Cisco Packet Data Gateway (PDG)
ACS Rulebase Configuration Mode Commands
fw-and-nat default-policy ▀
Command Line Interface Reference, StarOS Release 16 ▄
717
fw-and-nat default-policy
This command allows you to configure the default Firewall-and-NAT policy for the current rulebase. This command
must be used to configure the Policy-based Firewall-and-NAT feature.
must be used to configure the Policy-based Firewall-and-NAT feature.
Important:
This command is only available in StarOS 8.1 and StarOS 9.0 and later releases.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
fw-and-nat default-policy fw_nat_policy_name
no fw-and-nat default-policy
no
If previously configured, deletes the Firewall-and-NAT default policy configuration from the current
rulebase.
rulebase.
fw_nat_policy_name
Specifies the default Firewall-and-NAT policy for the current rulebase.
fw_nat_policy_name
must be the name of a Firewall-and-NAT policy, and must be an alphanumeric string
of 1 through 63 characters.
Usage
Use this command to configure the default Firewall-and-NAT policy for a rulebase.
For subscribers using the current rulebase, the default Firewall-and-NAT policy will be used if in the
APN/subscriber profile the
For subscribers using the current rulebase, the default Firewall-and-NAT policy will be used if in the
APN/subscriber profile the
default fw-and-nat policy
command is configured, and a policy to use is
not received from the AAA/OCS.
For more information, see the Personal Stateful Firewall Administration Guide.
For more information, see the Personal Stateful Firewall Administration Guide.
Example
The following command configures a Firewall-and-NAT policy named
standard
to the rulebase:
fw-and-nat default-policy standard