Cisco Cisco Packet Data Gateway (PDG)
Route-map Configuration Mode Commands
set ipv6 next-hop ▀
Command Line Interface Reference, StarOS Release 16 ▄
8099
set ipv6 next-hop
Sets the IPv6 address that is applied as the next hop for routes.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Route-map Configuration
configure > context context_name > route-map map_name { deny | permit }
seq_number
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-route-map)#
Syntax
[ no ] set ipv6 next-hop ipv6_address
no
Disables the specified next hop address.
ipv6_address
Specifies the IPv6 address of the next hop to which packets are output, entered using IPv6 colon-separated-
hexadecimal notation.
hexadecimal notation.
Usage
Use this command to set the IPv6 address that is used as the next hop for routes.
Example
To set the next hop for routes to the IPv6 address
2001:4A2B::1f3F
, use the following command:
set ip next-hop 2001:4A2B::1f3F
To disable setting the next hop for routes to the IP address
2001:4A2B::1f3F
, use the following command:
no set ip next-hop 2001:4A2B::1f3F