Cisco Cisco Packet Data Gateway (PDG)
Service Redundancy Protocol Configuration Mode Commands
▀ dead-interval
▄ Command Line Interface Reference, StarOS Release 16
8196
dead-interval
Defines the timeout interval before a peer is determined to be down.
Product
All products supporting ICSR
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
dead-interval interval
default dead-interval
default
Resets the dead interval to the default setting of 30 seconds.
interval
Specifies the amount of time (in seconds) for the dead interval.
interval
must be an integer from 1 through
65535. Default = 30.
Usage
This command specifies the amount of time that one chassis waits to receive a communication from a peer
before the listening chassis determines that the peer chassis is down.
before the listening chassis determines that the peer chassis is down.
Example
The following example sets the dead interval to 65 seconds:
dead-interval 65