Cisco Cisco Packet Data Gateway (PDG)
ACS Ruledef Configuration Mode Commands
▀ ip src-address
▄ Command Line Interface Reference, StarOS Release 16
946
ip src-address
This command allows you to define rule expressions to match the source IP address field within IP headers.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] ip src-address { operator { ipv4/ipv6_address | ipv4/ipv6_address/mask } | {
!range | range } host-pool host_pool_name }
!range | range } host-pool host_pool_name }
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
operator
: Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
ipv4/ipv6_address
Specifies IP address of the source node for incoming traffic.
ipv4/ipv6_address
must be an IP address in
IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
ipv4/ipv6_address/mask
Specifies the IP address of the source node for incoming traffic with subnet mask bit.
ipv4/ipv6_address/mask
must be an IP address in IPv4 dotted-decimal or IPv6 colon-separated-
hexadecimal notation with subnet mask bit. The mask bit is a numeric value which corresponds to the number
of bits in the subnet mask.
of bits in the subnet mask.
{ !range | range } host-pool host_pool_name
!range | range
: Specifies the range criteria:
!range
: Not in the range of
range
: In the range of