Cisco Cisco Packet Data Interworking Function (PDIF)
APN Configuration Mode Commands
▀ accounting-mode
▄ Command Line Interface Reference, StarOS Release 16
1260
accounting-mode
Configures the protocol to be used for PDP context accounting by this APN.
Product
eWAG
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
accounting-mode { gtpp | none | radius-diameter [ no-early-pdus ] [ no-interims ] }
default accounting-mode
default
Restores the command to its default setting.
gtpp
Configures the APN to use GPRS Tunneling Protocol Prime for accounting purposes. If used, accounting will
begin as soon as the PDP context is established. This is the default setting. Default: Enabled
begin as soon as the PDP context is established. This is the default setting. Default: Enabled
Important:
The system’s GTPP parameters must be configured prior to using this protocol for accounting. Refer
to the
gtpp
commands in the Context Configuration Mode Commands chapter.
none
Disables accounting for PDP contexts using this APN.
When accounting mode is set to none, it indicates to the GTP stack at session manager to not generate the
regular GTPP accounting triggers. Default: Disabled.
When accounting mode is set to none, it indicates to the GTP stack at session manager to not generate the
regular GTPP accounting triggers. Default: Disabled.
radius-diameter
Configures the APN to use RADIUS protocol for accounting purposes. Default: Disabled