Cisco Cisco Packet Data Interworking Function (PDIF)
APN Configuration Mode Commands
data-tunnel mtu ▀
Command Line Interface Reference, StarOS Release 16 ▄
1297
data-tunnel mtu
Configures the Maximum Transmission Unit (MTU) for data sent on the IPv6 tunnel between the P-GW and the mobile
node.
node.
Product
P-GW
SAEGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
data-tunnel mtubytes
default data-tunnel mtu
default
Returns the command to the default value of 1500.
bytes
Specifies the MTU for the IPv6 tunnel between the P-GW and the mobile node.
bytes
must be an integer
between 1280 and 2000. Default: 1500
Usage
Use this command to set the MTU for data traffic on the IPv6 tunnel between the P-GW and the mobile node.
Example
The following command sets the MTU for IPv6 data traffic to
1400
bytes:
data-tunnel mtu 1400