Cisco Cisco Packet Data Interworking Function (PDIF)
APN Configuration Mode Commands
dhcpv6 service-name ▀
Command Line Interface Reference, StarOS Release 16 ▄
1307
dhcpv6 service-name
Specifies which DHCPV6 service to use, if the alloc-type is configured as dhcpv6-client or dhcpv6-relay.
Product
GGSN
P-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
[ no ] dhcpv6 service-name service_name
no
Removes a previously configured DHCPv6 service name.
service_name
Configures the name of the DHCPv6 service instance that is to be used by the current APN for the dynamic
assignment of IPv6 addresses to PDP contexts. The name can be an alphanumeric string of 1 through 63
characters that is case sensitive.
assignment of IPv6 addresses to PDP contexts. The name can be an alphanumeric string of 1 through 63
characters that is case sensitive.
Usage
Use this command to specify a pre-configured DHCPv6 service instance that is to be used by the APN for
IPv6 address assignment when the Dynamic Host Control Protocol is used.
The name of the context in which the desired DHCP service is configured must be specified by the
IPv6 address assignment when the Dynamic Host Control Protocol is used.
The name of the context in which the desired DHCP service is configured must be specified by the
dhcpv6
context-name
command.
Important:
Only one DHCPv6 service can be configured for an APN
Example
The following command instructs the APN to use a DHCPv6 service called
dhcpv6_svc
:
dhcp service-name dhcpv6_svc