Cisco Cisco Packet Data Interworking Function (PDIF)
APN Profile Configuration Mode
▀ qos pgw-upgrade
▄ Command Line Interface Reference, StarOS Release 16
1504
qos pgw-upgrade
Configures the action to be taken when the MME receives a QoS upgrade from P-GW for default bearers/Non-
Guaranteed Bit Rate (Non-GBR) bearers.
Guaranteed Bit Rate (Non-GBR) bearers.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > APN Profile Configuration
configure > apn-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(apn-profile-profile_name)#
Syntax
qos pgw-upgrade non-gbr { accept | reject | locally-cap }
[ remove ] qos pgw-upgrade non-gbr
remove
Removes the configuration, returning the system to the default setting where the MME accepts the P-GW
upgraded QoS values for Non-GBR (default) bearers.
upgraded QoS values for Non-GBR (default) bearers.
non-gbr { accept | reject | locally-cap }
For Non-GBR (default) bearers, this keyword configures the action the MME takes when it receives a P-GW
upgraded QoS value.
upgraded QoS value.
accept
: The MME will accept the P-GW upgraded QoS values.
reject
: The MME will reject the P-GW upgraded QoS values.
locally-cap
: The MME compares QCI, ARP and ARP-PVI provided by P-GW to the locally
configured values of those parameters. If the values match, then accepts towards the P-GW and use
locally configured values towards the UE/RAN for APN-AMBR and ARP-PCI. If the values do not
match, the MME rejects the P-GW upgraded QoS values.
locally configured values towards the UE/RAN for APN-AMBR and ARP-PCI. If the values do not
match, the MME rejects the P-GW upgraded QoS values.
Usage
Use this command to provide configurability at the APN Profile level for the MME to accept, reject, or
locally-cap P-GW upgraded QoS values for default (non-GBR) bearers. This S11 Control is applied
whenever QoS parameters are received on S11 interface. The relevant procedures for default bearers are
Create Session Response (sent by P-GW during Attach, UE requested PDN connectivity) and Update Bearer
Procedures (initiated by P-GW resulting from trigger QoS change or other in PCEF/PCRF, or from Modify
Bearer Command or Bearer Resource Command sent by MME). Note: This configuration is supported only
for Default bearers (i.e Non-GBR bearers) in a roaming scenario.
The MME will set the sum of the APN-AMBR of all active APNs up to the value of the subscribed UE-
AMBR, subject to the UE-AMBR restriction.
locally-cap P-GW upgraded QoS values for default (non-GBR) bearers. This S11 Control is applied
whenever QoS parameters are received on S11 interface. The relevant procedures for default bearers are
Create Session Response (sent by P-GW during Attach, UE requested PDN connectivity) and Update Bearer
Procedures (initiated by P-GW resulting from trigger QoS change or other in PCEF/PCRF, or from Modify
Bearer Command or Bearer Resource Command sent by MME). Note: This configuration is supported only
for Default bearers (i.e Non-GBR bearers) in a roaming scenario.
The MME will set the sum of the APN-AMBR of all active APNs up to the value of the subscribed UE-
AMBR, subject to the UE-AMBR restriction.