Cisco Cisco Packet Data Interworking Function (PDIF)
Call Control Profile Configuration Mode
▀ attach imei-query-type
▄ Command Line Interface Reference, StarOS Release 16
1858
attach imei-query-type
Defines device Attach limitations for this call control profile if an IMEI is not already present in the Attach Request.
Product
MME
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
attach imei-query-type { imei | imei-sv | none } [ verify-equipment-identity [ allow-on-
eca-timeout | deny-greylisted | deny-unknown | verify-emergency ] + ]
eca-timeout | deny-greylisted | deny-unknown | verify-emergency ] + ]
remove attach imei-query-type
remove
Deletes the specified attach configuration.
imei-query-type { imei | imei-sv | none }
Configures system behavior during Attach procedures if an IMEI is not already present in the Attach Request.
imei
: Specifies that the system is required to query the UE for its International Mobile Equipment
Identity (IMEI).
imei-sv
: Specifies that the system is required to query the UE for its International Mobile Equipment
Identity - Software Version (IMEI-SV).
none
: Specifies that the system does not need to query for IMEI or IMEI-SV.
verify-equipment-identity [ allow-on-eca-timeout | deny-greylisted | deny-unknown
| verify-emergency ]
| verify-emergency ]
Specifies that the identification (IMEI or IMEI-SV) of the UE is to be performed by the Equipment Identity
Register (EIR) over the S13 interface.
Register (EIR) over the S13 interface.
allow-on-eca-timeout
: Configures the MME to allow equipment that has timed-out on ECA during
the attach procedure.
deny-greylisted
: Configures the MME to deny grey-listed equipment during the attach procedure.
deny-unknown
: Configures the MME to deny unknown equipment during the attach procedure.
verify-emergency
: Configures the MME to ignore the IMEI validation of the equipment during the
attach procedure in emergency cases. This keyword is only supported in release 12.2 and higher.