Cisco Cisco Packet Data Interworking Function (PDIF)
Channelized Port Configuration Mode Commands
▀ clock-source
▄ Command Line Interface Reference, StarOS Release 16
2110
clock-source
This command sets the source of the port’s transmit clock.
Important:
This command is only available for releases 8.1 or higher.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Channelized Port Configuration
configure > port channelized slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
clock-source { internal-timing | loop-timing }
default clock-source
default
Using this command combination sets the port clock source to internal timing.
internal-timing
Sets the port clock to derive timing from the recovered receive clock.
loop-timing
Sets the port clock to transmit in sync with the system timing.
Usage
Use this command for either SONET or SDH channelized (Frame Relay) ports on the SGSN.
Example
The following command resets the transmit clock source to internal timing.
default clock-source