Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands I-M
ip arp ▀
Command Line Interface Reference, StarOS Release 16 ▄
2457
ip arp
Configures the allocation retention priority (ARP) options for the current context.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
ip arp ip_address mac_address [ vrf vrf_name ]
no ip arp ip_address mac_address
no
Removes the ARP configuration data for the specified IP address from the configuration.
ip_address
Specifies the IP address for which to configure the ARP options where
ip_address
is an IP address
expressed in IPv4 dotted-decimal notation.
mac_address
Specifies the media-specific access control layer address for the IP address.
mac_address
must be specified
as a an 6-byte hexadecimal number with each byte separated by a colon, for example., “AA:12:bb:34:f5:0E”.
vrf
vrf_name
Associates a Virtual Routing and Forwarding (VRF) context with this static ARP entry.
vrf_name
is name of a preconfigured virtual routing and forwarding (VRF) context configured in Context
Configuration Mode via the
ip vrf
command.
Usage
Manage the IP address mapping which is a logical/virtual identifier to the more lower layer addressing used
for address resolution in ICMP messages.
For tunnel-based interface, network IP pool can have overlapping ip-addresses across Verve. To manage it
adding a preconfigured VRF context is required to associate with an static ARP entry. By default, the ARP is
added in the given context. If the VRF name is specified, then the ARP is added to the VRF ARP table.
for address resolution in ICMP messages.
For tunnel-based interface, network IP pool can have overlapping ip-addresses across Verve. To manage it
adding a preconfigured VRF context is required to associate with an static ARP entry. By default, the ARP is
added in the given context. If the VRF name is specified, then the ARP is added to the VRF ARP table.
Example
The following commands set the IP and MAC address for the current context then remove it from the
configuration:
configuration: