Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands S-Z
▀ saegw-service
▄ Command Line Interface Reference, StarOS Release 16
2676
saegw-service
Creates a System Architecture Evolution Gateway (SAEGW) service or specifies an existing SAEGW service and
enters the SAEGW Service Configuration Mode for the current context.
enters the SAEGW Service Configuration Mode for the current context.
Product
SAEGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
saegw-service service_name [ -noconfirm ]
no saegw-service service_name
no
Removes the specified SAEGW service from the context.
service_name
Specifies the name of the SAEGW service. If
service_name
does not refer to an existing service, the new
service is created if resources allow.
service_name
is an alphanumeric string of 1 through 63 characters.
Important:
Service names must be unique across all contexts within a chassis.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
Enter the SAEGW Service Configuration Mode for an existing service or for a newly defined service. This
command is also used to remove an existing service.
command is also used to remove an existing service.
Important:
An S-GW and/or P-GW created in the same context must be associated with this SAEGW service.
A maximum of 256 services (regardless of type) can be configured per system.
Caution:
Large numbers of services greatly increase the complexity of management and may impact overall
system performance (for example, resulting from such things as system handoffs). Therefore, it is recommended that a