Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands S-Z
threshold ip-pool-release ▀
Command Line Interface Reference, StarOS Release 16 ▄
2705
threshold ip-pool-release
Sets an alert based on the percentage of IP addresses from an IP pool that are in the release state. This command affects
all IP pools in the current context.
all IP pools in the current context.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
threshold ip-pool-release high_thresh [ clear low_thresh ]
default threshold ip-pool-release
default
Configures the default setting.
high_thresh
Sets the high threshold percentage of addresses in the release state in an IP pool that must be met or exceeded
within the polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 100.
Default: 0
within the polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 100.
Default: 0
clear low_thresh
Sets the low threshold percentage of addresses in the release state in an IP pool that maintains a previously
generated alarm condition. If the utilization percentage rises below the low threshold within the polling
interval, a clear alarm will be generated. It may be configured as an integer from 0 through 100. Default:0
generated alarm condition. If the utilization percentage rises below the low threshold within the polling
interval, a clear alarm will be generated. It may be configured as an integer from 0 through 100. Default:0
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the low threshold.
Usage
Use this command to set an alert or an alarm when the number of IP addresses the release state in any pool is
equal to or greater than a specified percentage of the total number of addresses in the pool.
Alerts or alarms are triggered for percentage of IP address pool addresses in the release state based on the
following rules:
equal to or greater than a specified percentage of the total number of addresses in the pool.
Alerts or alarms are triggered for percentage of IP address pool addresses in the release state based on the
following rules:
Enter Condition: Actual percentage of IP addresses in the release state per pool> High Threshold
Clear Condition: Actual percentage of IP addresses in the release state per pool < Low Threshold