Cisco Cisco Packet Data Interworking Function (PDIF)
Diameter Host Select Configuration Mode Commands
host-select table ▀
Command Line Interface Reference, StarOS Release 16 ▄
3471
host-select table
This command configures a table of peer servers associated with the Diameter host template.
Product
GGSN
HA
HSGW
IPSG
PDSN
P-GW
SCM
SAEGW
S-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Diameter Host Select Configuration
configure > diameter-host-template template_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-host-template)#
Syntax
In StarOS 14.1 and earlier releases:
host-select table { 1 | 2 | prefix-table { 1 | 2 } } algorithm { ip-address-modulus [
prefer-ipv4 | prefer-ipv6 ] | msisdn-modulus | round-robin }
prefer-ipv4 | prefer-ipv6 ] | msisdn-modulus | round-robin }
no host-select table
In StarOS 15.0 and later releases:
host-select table { 1 | 2 | range-table { 1 | 2 } } algorithm { ip-address-modulus [
prefer-ipv4 | prefer-ipv6 ] | msisdn-modulus | round-robin }
prefer-ipv4 | prefer-ipv6 ] | msisdn-modulus | round-robin }
no host-select table
no
Removes the table associated with the Diameter host template.
table { 1 | 2 | prefix-table { 1 | 2 } }
Important:
This command syntax is applicable to StarOS release 14.1 and earlier.