Cisco Cisco Packet Data Interworking Function (PDIF)
Ethernet Port Configuration Mode Commands
▀ vlan
▄ Command Line Interface Reference, StarOS Release 16
3662
vlan
Enters VLAN Configuration mode. Creates VLAN if necessary.
Product
HA
HSGW
PDSN
P-GW
SAEGW
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
vlan vlan_id [ inline-process | subscriber-vlan ] [ -noconfirm]
vlan_id
Specifies a VLAN identifier as an integer from 1 through 4094. If this identifier does not already exist you
are prompted to confirm the identifier an a new one is created.
are prompted to confirm the identifier an a new one is created.
inline-process
Specifies that this VLAN will be used for inline processing.
subscriber-vlan
Specifies that this VLAN will be used for subscriber-based processing.
-noconfirm
Specifies that the command must execute without any prompts and confirmation from the user.
Usage
Use this command to specify an existing VLAN ID or create a new VLAN ID and enter the VLAN
Configuration mode.
For additional information, refer to the VLAN Configuration Mode Commands chapter.
Configuration mode.
For additional information, refer to the VLAN Configuration Mode Commands chapter.
Example
The following command creates the VLAN ID
234
.