Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode Commands (D-S)
▀ debug ip
▄ Command Line Interface Reference, StarOS Release 16
3928
debug ip
Enables or disables the debug options for IP debugging. If logging is enabled, results are sent to the logging system.
Product
All
Privilege
Security Administrator, Administrator, Operator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
[ no ] debug ip { arp | interface | route }
no
Indicates the IP debugging is to be disabled for the IP interfaces/function specified.
arp | interface name | route
Specifies which IP interfaces/function to debug.
arp
: indicates debug is to be enabled for the address resolution protocol.
interface
: indicates debug is to be enabled for the IP interfaces.
route
: indicates debug is to be enabled for the route selection and updates.
Usage
The debug IP command is valuable when troubleshooting network problems between nodes. The debugging
is stopped by using the
is stopped by using the
no
keyword.
Caution:
Issuing this command could negatively impact system performance depending on system
configuration and/or loading.
Example
The following commands enable/disable debugging for ARP.
debug ip arpno debug ip arp
The following enables/disables debugging for IP interfaces.
debug ip interface
no debug ip interface
The following enables/disables debugging for routing.
debug ip routeno debug ip route