Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode Commands (D-S)
dhcp force ▀
Command Line Interface Reference, StarOS Release 16 ▄
3955
dhcp force
Tests the lease-renewal for DHCP-assigned IP addresses for a particular subscriber.
Product
GGSN
ASN-GW
P-GW
SAEGW
Privilege
Security Administrator, Administrator, Operator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
dhcp force lease-renewal { callid id | imsi imsi [ nsapi nsapi ] | msid msid }
callid
id
Clears the call ID specified as a 4-byte hexadecimal number.
imsi
msid
Disconnects the subscriber with the specified msid. The IMSI (International Mobile Subscriber Identity) ID is
a 50-bit field which identifies the subscriber’s home country and carrier. Wildcard characters $ and * are
allowed. The * wildcard matches multiple characters and the $ wildcard matches a single character. If you do
not want the wildcard characters interpreted as a wildcard enclose them in single quotes ( ‘ ). For example;
‘$’.
a 50-bit field which identifies the subscriber’s home country and carrier. Wildcard characters $ and * are
allowed. The * wildcard matches multiple characters and the $ wildcard matches a single character. If you do
not want the wildcard characters interpreted as a wildcard enclose them in single quotes ( ‘ ). For example;
‘$’.
nsapi
nsapi
Specifies a Network Service Access Point Identifier (NSAPI) an integer from 5 to 15.
msid
id
Disconnects the mobile user identified by
ms_id
.
ms_id
must be from 7 to 16 digits specified as an IMSI,
MIN, or RMI. Wildcard characters $ and * are allowed. The * wildcard matches multiple characters and the $
wildcard matches a single character. If you do not want the wildcard characters interpreted as a wildcard
enclose them in single quotes ( ‘ ). For example; ‘$’.
wildcard matches a single character. If you do not want the wildcard characters interpreted as a wildcard
enclose them in single quotes ( ‘ ). For example; ‘$’.
Usage
Use this command tests a forced IP address lease renewal for a specific subscriber.
Example
The following command tests DHCP lease renewal for a subscriber with an MSID of
1234567
:
dhcp force lease-renewal msid 1234567