Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode Commands (D-S)
▀ srp initiate-switchover
▄ Command Line Interface Reference, StarOS Release 16
4112
srp initiate-switchover
Changes the device status on the primary and backup systems configured for Interchassis Session Recovery (ICSR)
support employing Service Redundancy Protocol (SRP).
support employing Service Redundancy Protocol (SRP).
Product
All products that support ICSR
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
srp initiate-switchover [ force | post-processing-timeout | reset-route-modifier |
timeout seconds ] [ -noconfirm ]
timeout seconds ] [ -noconfirm ]
force
Switchover by force, without any validating checks.
post-processing-timeout
Specifies the timeout value (in seconds) to initiate the post-switchover process as an integer from 0 through
3600.
3600.
reset-route-modifier
During a switchover, resets the route-modifier to the initial value.
timeout
seconds
Specifies the number of seconds before a forced switchover occurs as an integer from 0 through 65535.
Default: 300
Default: 300
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
This command executes a forced switchover from active to inactive. The command must be executed on the
active system and switches the active system to the inactive state and the inactive system to an active state.
active system and switches the active system to the inactive state and the inactive system to an active state.
Example
The following initiates a switchover in
30
seconds.
srp initiate-switchover timeout 30