Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode show Commands (H-L)
▀ show linecard
▄ Command Line Interface Reference, StarOS Release 16
4600
show linecard
Displays information on the interface cards installed in the rear of the system chassis.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
show linecard { dlci-utilization card# | table } [ | { grep grep_options | more } ]
dlci-utilization card#
SGSN only
In tabular format, displays current data link utilization (in 5 minute and 15 minute breakdowns) information
for all Frame Relay ports on the specified CLC-type line card. Data links are referred to by data link
connection identifiers (DLCI).
In tabular format, displays current data link utilization (in 5 minute and 15 minute breakdowns) information
for all Frame Relay ports on the specified CLC-type line card. Data links are referred to by data link
connection identifiers (DLCI).
card#
- Identifies the chassis slot number where the line card resides. Enter an integer from 1 to 48.
table
Displays information on all line card slots in tabular format.
| { grep
grep_options
| more }
Pipes (sends) the output of this command to the specified command. You must specify a command to which
the output of this command will be sent.
For details on the usage of
the output of this command will be sent.
For details on the usage of
grep
and
more
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter.
Usage
Use this command to show the line card information
to verify hardware inventories and installed components.
to review DLCI utilization for a specific Frame Relay channelized line card.
Important:
This command is not supported on all platforms.
Example
Use the following command to display a table with information identifying all line cards installed in the
chassis:
chassis:
show linecard table