Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode show Commands (M-P)
▀ show power
▄ Command Line Interface Reference, StarOS Release 16
4710
show power
Displays information about the power on/off status of individual cards and the operating status of installed power filter
units.
units.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
show power [ all | chassis | card_num ] [ | { grep grep_options | more } ]
all | chassis | card_num ]
all
: Displays power on/off state for all cards in the chassis.
chassis
: Displays the operating status of installed power filter units. This is the default setting.
card_num
: Displays the power on/off state for a single card specified an integer from 1 through 48 for the
ASR 5000 or 1 through 20 for the ASR 5500.
| { grep grep_options | more }
Pipes (sends) the output of the command to the command specified. You must specify a command to which
the output will be sent.
For details on the usage of
the output will be sent.
For details on the usage of
grep
and
more
, refer to the Regulating a Command’s Output section in the
Command Line Interface Overview chapter.
Usage
View power source information to quickly check the power for all cards within a chassis.
Important:
On some platforms, only
show power
is supported with no other keywords or variables.
Example
The following displays power supply status for the chassis:
show power
The following command displays the power status for all slots:
show power all