Cisco Cisco Packet Data Interworking Function (PDIF)
FA Service Configuration Mode Commands
multiple-reg ▀
Command Line Interface Reference, StarOS Release 16 ▄
4941
multiple-reg
Specifies the number of simultaneous Mobile IP sessions that will be supported for over a single PPP session.
Product
PDSN
ASN-GW
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > FA Service Configuration
configure > context context_name > fa-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-fa-service)#
Syntax
multiple-reg number
number
number
can be configured to an integer from 1 through 3.
Usage
Use to support multiple registrations per subscriber.
The system defaults to a setting of “1” for multiple simultaneous MIP sessions.
The system defaults to a setting of “1” for multiple simultaneous MIP sessions.
Important:
The system will only support multiple Mobile IP sessions per subscriber if the subscriber’s mobile
node has a static IP address. The system will only allow a single Mobile IP session for mobile nodes that receive a
dynamically assigned IP address. In addition, because only a single Mobile IP or proxy-Mobile IP session is supported
for IP PDP contexts, this parameter must remain at its default configuration.
dynamically assigned IP address. In addition, because only a single Mobile IP or proxy-Mobile IP session is supported
for IP PDP contexts, this parameter must remain at its default configuration.
Example
The following command configures the number of supported simultaneous registrations for subscribers using
this FA service to
this FA service to
3
.
multiple-reg 3