Cisco Cisco Packet Data Interworking Function (PDIF)
Firewall-and-NAT Policy Configuration Mode Commands
▀ nat check-point-info
▄ Command Line Interface Reference, StarOS Release 16
4998
nat check-point-info
This command enables or disables the checkpointing of basic NAT, H323 and SIP ALG recovery. ICSR recovery can
also be enabled or disabled for basic NAT and SIP flows.
also be enabled or disabled for basic NAT and SIP flows.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-fw-and-nat-policy)#
Syntax
[ default | no ] nat check-point-info { basic [ icsr-also | limit-flows limit ] | h323-
alg | sip-alg [ icsr-also ] }
alg | sip-alg [ icsr-also ] }
default
Configures this command with its default setting.
Default: Disabled
Default: Disabled
no
Disables the basic NAT recovery and stand-alone H323 ALG and SIP ALG recovery. Also disables ICSR
recovery for SIP ALG.
recovery for SIP ALG.
basic [ icsr-also | limit-flows limit ]
Configures the basic flow checkpointing information.
icsr-also
: Enables checkpointing for ICSR.
limit-flows
: Limits the specified flows for basic NAT checkpointing.
limit
must be an integer
from 1 through 100.
Default: 100
h323-alg
Enables checkpointing of H323 ALG.
sip-alg [ icsr-also ]
Enables checkpointing of SIP ALG.
icsr-also
: Enables checkpointing for ICSR.