Cisco Cisco Packet Data Interworking Function (PDIF)
Firewall-and-NAT Access Ruledef Configuration Mode Commands
ip protocol ▀
Command Line Interface Reference, StarOS Release 16 ▄
5025
ip protocol
This command configures an access ruledef to analyze user traffic based on the protocol being transported by IP
packets.
packets.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Access Ruledef Configuration
active-charging service service_name > access-ruledef access_ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-fw-ruledef)#
Syntax
[ no ] ip protocol { { operator { protocol | protocol_assignment } } | { operator
protocol_assignment } }
protocol_assignment } }
no
Removes previously configured IP protocol address ruledef.
operator { protocol | protocol_assignment }
operator
: Specifies how to logically match the IP protocol.
operator
must be one of the following:
!=
: Does not equal
=
: Equals
protocol
: Specifies the protocol by name.
protocol
must be one of the following:
ah
esp
gre
icmp
tcp
udp
protocol_assignment
: Specifies the protocol by assignment number.
protocol_assignment
must be
an integer from 0 through 255 (for example, 1 for ICMP, 6 for TCP, and 17 for UDP).
operator protocol_assignment
operator
: Specifies how to logically match the IP protocol.
operator
must be one of the following: