Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (A-K)
▀ congestion-control threshold port-specific
▄ Command Line Interface Reference, StarOS Release 16
5210
congestion-control threshold port-specific
Configures the congestion thresholds for specific port utilization.
Important:
This command applies to ePDG (version 14.1 and higher).
Product
ePDG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
congestion-control threshold port-specific { slot/port [ tx-utilization { critical
percent | major percent | minor percent ] [ rx-utilization { critical percent | major
percent | minor percent } | all { critical percent | major percent | minor percent } }
percent | major percent | minor percent ] [ rx-utilization { critical percent | major
percent | minor percent } | all { critical percent | major percent | minor percent } }
no congestion-control threshold port-specific { slot/port { critical | major | minor } |
all { critical | major | minor } }
all { critical | major | minor } }
no congestion-control threshold port-specific { slot/port { critical | major |
minor } | all { critical | major | minor } }
minor } | all { critical | major | minor } }
Sets all port-specific utilization thresholds to the default values.
slot/port
Default: Disabled
Specifies the port for which port specific threshold monitoring is being configured. The slot and port must
refer to an installed card and port. If you set port-specific thresholds, when any individual port-specific
threshold is reached, congestion control is applied system-wide.
Specifies the port for which port specific threshold monitoring is being configured. The slot and port must
refer to an installed card and port. If you set port-specific thresholds, when any individual port-specific
threshold is reached, congestion control is applied system-wide.
all
Set threshold monitoring for all ports on all cards.
rx-utilization
Set threshold monitoring for received data only.
tx-utilization
Set threshold monitoring for transmitted data only.