Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (L-S)
▀ port atm
▄ Command Line Interface Reference, StarOS Release 16
5342
port atm
Identifies a physical port on a line card that supports ATM signaling and then enters the configuration mode for the
specific interface-type. For the commands to configure the port interface, see the CLI chapter ATM Port Configuration
Mode.
specific interface-type. For the commands to configure the port interface, see the CLI chapter ATM Port Configuration
Mode.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
port atm slot/port
atm
Indicates the port identified is an ATM interface port.
slot/port
To determine valid ATM slot and port numbers, use the Exec mode’s command
show port table
slot:
Identifies the chassis slot holding the line card that supplies ATM ports. The slot ID number can be an
integer from 17 through 48.
port:
Identifies the physical port that is to be configured to support ATM signaling. The ID number can be
an integer from 1 through 4.
Usage
Change the current configuration mode to Ethernet Port Configuration mode.
Important:
This command is not supported on all platforms.
Example
The following enters the ATM port configuration mode for ATM port 1 on the card in slot 19:
port atm 19/1