Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Configuration Mode Commands
▀ policy-control bearer-bw-limit
▄ Command Line Interface Reference, StarOS Release 16
536
policy-control bearer-bw-limit
This command allows you to enable/disable per-bearer MBR policing—bandwidth limiting.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
{ default | no } policy-control bearer-bw-limit
default
Configures this command with its default setting.
Default: Enable; by default, per-bearer MBR policing is enabled.
Default: Enable; by default, per-bearer MBR policing is enabled.
no
Disables per-bearer MBR policing.
Usage
This command allows you to enable/disable per-bearer bandwidth limiting based on bitrates received over
Gx. Note that there are only two variants of this command, the default and no variants.
Gx. Note that there are only two variants of this command, the default and no variants.