Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
threshold asnpc-lu-denial ▀
Command Line Interface Reference, StarOS Release 16 ▄
5473
threshold asnpc-lu-denial
Configures the alarm or alert thresholds for Location Update (LU) denials.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold asnpc-lu-denial high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of LU denials during session that must be met or exceeded within the
polling interval to generate an alert or alarm.
Specifies the high threshold number of LU denials during session that must be met or exceeded within the
polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of LU denials during session that maintains a previously generated alarm
condition. If the number of session timeouts falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
Specifies the low threshold number of LU denials during session that maintains a previously generated alarm
condition. If the number of session timeouts falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
low_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Set the maximum number of Location Update denials allowed in the ASNPC service.
Example
The following command configures high threshold of
10000
LU denials:
threshold asnpc-lu-denial 10000