Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold mgmt-cpu-utilization
▄ Command Line Interface Reference, StarOS Release 16
5540
threshold mgmt-cpu-utilization
Configures alarm or alert thresholds for the percentage of CPU utilization on management cards.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold mgmt-cpu-utilization high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold CPU utilization percentage that must be met or exceeded within the polling
interval to generate an alert or alarm.
Specifies the high threshold CPU utilization percentage that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 100.
clear
low_thresh
Specifies the low threshold CPU utilization percentage that maintains a previously generated alarm condition.
If the utilization percentage falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
If the utilization percentage falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
low_thresh
is an integer from 0 through 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
CPU utilization thresholds generate alerts or alarms based on the utilization percentage of each SPC, SMC, or
MIOCPU during the specified polling interval. Although, a single threshold is configured for both SPC,
SMC, or MIO CPUs, separate alerts or alarms can be generated for each CPU.
Alerts or alarms are triggered for SPC, SMC, or MIO CPU utilization based on the following rules:
MIOCPU during the specified polling interval. Although, a single threshold is configured for both SPC,
SMC, or MIO CPUs, separate alerts or alarms can be generated for each CPU.
Alerts or alarms are triggered for SPC, SMC, or MIO CPU utilization based on the following rules:
Enter condition: Average measured CPU utilization for the last 5 minutes is greater than or equal to
the high threshold.
Clear condition: Average measured CPU utilization for the last 5 minutes is less than the low
threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
of the polling interval.