Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands A - N)
threshold poll cpu-available-memory interval ▀
Command Line Interface Reference, StarOS Release 16 ▄
5653
threshold poll cpu-available-memory interval
Configures the polling interval over which to measure the percentage of total packet processing card CPU memory used.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll cpu-available-memory intervalduration
default threshold poll cpu-available-memory interval
default
Uses the default threshold polling interval.
Default: 300 seconds
Default: 300 seconds
interval
dur
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 30 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshCPUMemory
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the CPU available memory
threshold:
threshold poll cpu-available-memory interval 600