Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll nat-port-chunks-usage interval
▄ Command Line Interface Reference, StarOS Release 16
5708
threshold poll nat-port-chunks-usage interval
Configures the polling interval over which to measure the percentage of Network Address Translation (NAT) port
chunk utilization.
chunk utilization.
Product
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll nat-port-chunks-usage interval duration
default threshold poll nat-port-chunks-usage interval
default
Restores the specified poll interval value to its default value of 900 seconds.
interval duration
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 30 through 60000.
Default: 900 seconds.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshNATPortChunksUsage
command in this mode.
Example
The following command configures the polling interval to
600
seconds for (NAT) port chunk utilization:
threshold poll nat-port-chunks-usage interval 600