Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands O - Z)
▀ threshold poll rp-setup-fail-rate interval
▄ Command Line Interface Reference, StarOS Release 16
5752
threshold poll rp-setup-fail-rate interval
Configures the polling interval over which to measure the percentage of RAN PDSN (RP) setup failures.
Product
PDSN
Privilege
Administrator Security Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll rp-setup-fail-rate interval dur
default threshold poll route-service interval
default
Restores the threshold poll interval value to its default value of 900 seconds.
interval
time
Default: 900 seconds
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
dur
is any integer from 30 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold model
and
threshold monitoring
commands for additional information on the
system’s support for thresholding.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshRPSetupFailRate
command in this mode.
Example
The following command configures the polling interval for the RP setup fail rate polling duration value to
600
seconds (10 minutes):
hreshold poll rp-setup-fail-rate interval 600