Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Packet Filter Configuration Mode Commands
priority ▀
Command Line Interface Reference, StarOS Release 16 ▄
611
priority
This command allows you to configure the current packet filter’s priority.
Important:
This command is deprecated in certain 9.0 releases and in 10.0 and later releases. The precedence
values of packet filters (those from both dynamic and predefined rules) are assigned by the PCEF based on an internal
process.
process.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Packet Filter Configuration
active-charging service service_name > packet-filter packet_filter_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-packet-filter)#
Syntax
priority priority
no priority
no
If previously configured, deletes the priority configuration in the current packet filter.
priority
Specifies this packet filter’s priority
priority
must be an integer from 0 through 255.
Usage
Use this command to configure the packet filter’s priority. The priority must be configured for the packet
filter to be used in a TFT. Packets are compared against packet filters in a prioritized fashion, with 0 being the
highest priority. Without this setting, this filter will not be used.
filter to be used in a TFT. Packets are compared against packet filters in a prioritized fashion, with 0 being the
highest priority. Without this setting, this filter will not be used.
Example
The following command configures the packet filter’s priority as
3
:
priority 3