Cisco Cisco Packet Data Interworking Function (PDIF)
HNB-GW Service Configuration Mode Commands
▀ ip iuh-qos-dscp
▄ Command Line Interface Reference, StarOS Release 16
6274
ip iuh-qos-dscp
Enables or disables the DSCP marking parameter for control and data packets transmitted over an IuH interface towards
HNB. By default this command is Disabled.
HNB. By default this command is Disabled.
Platform
ASR 5000
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HNB-GW Service Configuration
configure > context context_name > hnbgw-service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-hnbgw-service)#
Syntax
ip iuh-qos-dscp protocol { sctp payload all | udp payload { gtpu | rtcp| rtp} } dscp_code
[default | no] ip iuh-qos-dscp protocol { sctp payload all | udp payload { gtpu | rtcp|
rtp} }
rtp} }
no
Use this keyword to set the configuration in pass-through mode. Use of this keyword is allowed even when
there is no previous DSCP parameter set.
there is no previous DSCP parameter set.
Important:
In this configuration the
no
keyword does not disable/remove a previous
configuration.
default
Enables the DSCP marking on HNB-GW and set/restores the QoS parameters to its default setting.
sctp
payload
all
dscp_code
Specifies the QOS traffic pattern towards HNB in SCTP protocol association over IuH interface.
By this keyword the Traffic classes specified by a user based on SCTP protocol and all type of payload
identified based on the transport level port numbers.
By default DSCP codes cs5 is supported for
By this keyword the Traffic classes specified by a user based on SCTP protocol and all type of payload
identified based on the transport level port numbers.
By default DSCP codes cs5 is supported for
all
payloads in SCTP protocol.
udp payload { gtpu | rtcp| rtp} dscp_code
Specifies the QOS traffic pattern towards HNB in SCTP protocol association over IuH interface.
By this keyword the Traffic classes specified by a user based on UDP protocol and GTPU, RTCP, and RTP
type of payload identified based on the transport level port numbers.
Default DSCP code in UDP traffic are:
By this keyword the Traffic classes specified by a user based on UDP protocol and GTPU, RTCP, and RTP
type of payload identified based on the transport level port numbers.
Default DSCP code in UDP traffic are: