Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
▀ billing-records
▄ Command Line Interface Reference, StarOS Release 16
638
billing-records
This command allows you to configure the type of billing to be performed for subscriber sessions.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
billing-records { egcdr | radius | rf | udr udr-format udr_format_name [ failure-
handling-udr-format udr_format_name ] } +
handling-udr-format udr_format_name ] } +
no billing-records
no
If previously configured, deletes the billing-records configuration from the current rulebase.
egcdr
Generates an enhanced G-CDR (eG-CDR) for GGSN / P-GW-CDR for P-GW, and/or UDR with specified
format on the occurrence of an interim trigger condition at the end of a subscriber session, or an SGSN-to-
SGSN handoff.
format on the occurrence of an interim trigger condition at the end of a subscriber session, or an SGSN-to-
SGSN handoff.
radius
Generates postpaid RADIUS accounting records at the start and end of a subscriber session, and on the
occurrence of an interim trigger condition. RADIUS accounting records are generated for each content ID.
occurrence of an interim trigger condition. RADIUS accounting records are generated for each content ID.
Important:
In the GGSN, if in the APN configuration the “accounting-mode” is set to “none”, the system
continues to send ACS-generated RADIUS accounting messages. In the PDSN, if in the subscriber default configuration
the “accounting-mode” is set to “none”, the system does not send any RADIUS accounting messages (including ACS
accounting messages).
the “accounting-mode” is set to “none”, the system does not send any RADIUS accounting messages (including ACS
accounting messages).
rf
Enables Rf accounting.
Rf accounting is applicable only for dynamic and predefined rules that are marked for it. Dynamic rules have
a field offline-enabled to indicate this. To mark a predefined rule as offline-enabled, use this keyword and the
Rf accounting is applicable only for dynamic and predefined rules that are marked for it. Dynamic rules have
a field offline-enabled to indicate this. To mark a predefined rule as offline-enabled, use this keyword and the
billing-action
command in the ACS Charging Action Configuration Mode.