Cisco Cisco Packet Data Interworking Function (PDIF)
IPv6 ACL Configuration Mode Commands
▀ deny/permit (by source IP address masking)
▄ Command Line Interface Reference, StarOS Release 16
6496
deny/permit (by source IP address masking)
Used to filter subscriber sessions based on the IPv6 address mask sent by the source to the mobile node or the network.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IPv6 ACL Configuration
configure > context context_name > ipv6 access-list ipv6_acl_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ipv6-acl)#
Syntax
{ deny | permit } [ log ] source_address source_wildcard
after { deny | permit } [ log ] source_address source_wildcard
before { deny | permit } [ log ] source_address source_wildcard
no { deny | permit } [ log ] source_address source_wildcard
after
Indicates all rules defined subsequent to this command are to be inserted after the command identified by the
exact options listed.
This moves the insertion point to be immediately after the rule which matches the exact options specified
such that new rules will be added, in order, after the matching rule.
exact options listed.
This moves the insertion point to be immediately after the rule which matches the exact options specified
such that new rules will be added, in order, after the matching rule.
Important:
If the options specified do not exactly match an existing rule, the insertion point does not change.
before
Indicates all rules defined subsequent to this command are to be inserted before the command identified by
the exact options listed.
This moves the insertion point to be immediately before the rule which matches the exact options specified
such that new rules will be added, in order, before the matching rule.
the exact options listed.
This moves the insertion point to be immediately before the rule which matches the exact options specified
such that new rules will be added, in order, before the matching rule.
Important:
If the options specified do not exactly match an existing rule, the insertion point does not change
no
Removes the rule which exactly matches the options specified.
deny | permit
Specifies the rule is either block (deny) or an allow (permit) filter.