Cisco Cisco Packet Data Interworking Function (PDIF)
IPv6 ACL Configuration Mode Commands
deny/permit (by source ICMP packets) ▀
Command Line Interface Reference, StarOS Release 16 ▄
6503
deny/permit (by source ICMP packets)
Used to filter subscriber sessions based on the internet control message protocol packets sent by the source to the mobile
node or the network.
node or the network.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IPv6 ACL Configuration
configure > context context_name > ipv6 access-list ipv6_acl_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ipv6-acl)#
Syntax
{ deny | permit } [ log ] icmp { source_address source_wildcard | any | host
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
after { deny | permit } [ log ] icmp { source_address source_wildcard | any | host
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
before { deny | permit } [ log ] icmp { source_address source_wildcard | any | host
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
no { deny | permit } [ log ] icmp { source_address source_wildcard | any | host
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
source_host_address } { dest_address dest_wildcard | any | host dest_host_address } [
icmp_type [ icmp_code ] ]
after
Indicates all rules defined subsequent to this command are to be inserted after the command identified by the
exact options listed.
This moves the insertion point to be immediately after the rule which matches the exact options specified
such that new rules will be added, in order, after the matching rule.
exact options listed.
This moves the insertion point to be immediately after the rule which matches the exact options specified
such that new rules will be added, in order, after the matching rule.
Important:
If the options specified do not exactly match an existing rule, the insertion point does not change.
before
Indicates all rules defined subsequent to this command are to be inserted before the command identified by
the exact options listed.
This moves the insertion point to be immediately before the rule which matches the exact options specified
such that new rules will be added, in order, before the matching rule.
the exact options listed.
This moves the insertion point to be immediately before the rule which matches the exact options specified
such that new rules will be added, in order, before the matching rule.