Cisco Cisco Packet Data Interworking Function (PDIF)
Loopback Interface Configuration Mode Commands
ipv6 address ▀
Command Line Interface Reference, StarOS Release 16 ▄
6861
ipv6 address
Use this command to configure the IPv6 options for the current interface.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Loopback Interface Configuration
configure > context context_name > interface interface_name loopback
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-if-loopback)#
Syntax
ipv6 address ipv6_address ip_mask [ srp-activate ]
no iv6p address ipv6_address
no
Deletes the specified IPv6 address from the interface configuration.
address
ipv6_address
ip_mask
Configures the IP address and network mask for the interface.
ipv6_address ip_mask
specifies an IP address and the subnet mask pair that identifies the IPv6 address of
the interface. Specify
ipv6_address
in IPv6 colon-separated-hexadecimal notation.
srp-activate
Activates the IPv6 address for Session Recovery.
Usage
Create and manage loopback interfaces for the current context and enable Session Redundancy Protocol
(SRP) when appropriate.
(SRP) when appropriate.
Example
The following command configures an IPv6 address to associate with the interface and enables SRP:
ipv6 address 2001:268:2008:b::1021/128 srp-activate