Cisco Cisco Packet Data Interworking Function (PDIF)
LTE Policy Configuration Mode Commands
▀ subscriber-map
▄ Command Line Interface Reference, StarOS Release 16
6952
subscriber-map
Creates a subscriber map or specifies an existing subscriber map and enters the Subscriber Map Configuration Mode.
Product
MME
ePDG
SAEGW
S-GW
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration
configure > lte-policy
Entering the above command sequence results in the following prompt:
[local]host_name(lte-policy)#
Syntax
[ no ] subscriber-map map_name [ -noconfirm ]
no
Removes the specified subscriber map from the system.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
map_name
Specifies the name of the subscriber map. If the map name does not refer to an existing map, a new map is
created.
created.
map_name
must be an alphanumeric string of 1 through 64 characters.
Usage
Enter the Subscriber Map Configuration Mode for an existing or newly defined map. This command is also
used to remove an existing map.
Entering this command results in the following prompt:
used to remove an existing map.
Entering this command results in the following prompt:
hostname(subscriber-map)#
Subscriber Map Configuration Mode commands are defined in the LTE Subscriber Map Configuration Mode
Commands chapter.
Commands chapter.
Example
The following command enters the existing Subscriber Map Configuration Mode (or creates it if it does not
already exist) for the map named
already exist) for the map named
map1
:
subscriber-map map1