Cisco Cisco Packet Data Interworking Function (PDIF)
MME LAC Pool Area Configuration Mode Commands
▀ lac
▄ Command Line Interface Reference, StarOS Release 16
7050
lac
Configures a 3G location area code or area codes that define this pool area.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > SGs Service Configuration > MME LAC Pool Area
Configuration
Configuration
configure > context context_name > sgs-service service_name > pool-area pool_area_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgs-pool-area)#
Syntax
[ no ] lac { area_code } +
no
Removes a configured forbidden handover area code or area codes from this policy. If no location area code
is specified, then all location area codes are removed.
is specified, then all location area codes are removed.
area_code
Specifies an area code or area codes used to select a VLR for the pool area as an integer from 0 through
65535. Multiple area codes can be entered (up to 16 in a single line, separated by spaces).
65535. Multiple area codes can be entered (up to 16 in a single line, separated by spaces).
Usage
Use this command to configure 3G location-based area codes that define this pool area.
In Release 12.2 and later, a maximum of 96 areas can be added per pool area (in a single line, or separately).
In older releases, a total of 16 area codes can be added (in a single line, or separately).
In Release 12.2 and later, a maximum of 96 areas can be added per pool area (in a single line, or separately).
In older releases, a total of 16 area codes can be added (in a single line, or separately).
Example
The following command configures eight location-based area codes (1, 2, 3, 4, 5, 6, 7, 8) that define this pool
area:
area:
lac 1 2 3 4 5 6 7 8