Cisco Cisco Packet Data Interworking Function (PDIF)
MPLS-LDP Configuration Mode Commands
▀ session
▄ Command Line Interface Reference, StarOS Release 16
7212
session
Configures the LDP session parameters.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MPLS-IP Configuration > MPLS-LDP Configuration
configure > context context_name > mpls-ip > protocol ldp
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ldp)#
Syntax
session timers { hold-interval integer_value | keepalive-interval integer_value }
default session timers
default
Configures the default values for hold-interval parameter at 45 and keepalive-interval parameter at 15.
timers
Configures the LDP session keepalive parameters.
hold-interval
integer_value
Configures the session hold time interval in seconds.
integer_value
is an integer from 45 through 65535.
Default: 45
keepalive-interval
integer_value
Configures the frequency of sending keepalive packets in seconds.
integer_value
is an integer from 15 through 21845.
Default: 15
Usage
This optional command is used to configure LDP session timers. LDP session hold-interval is always set to
three times the LDP session keepalive-interval. The “default” option sets the session keepalive and hold
intervals to the default values.
three times the LDP session keepalive-interval. The “default” option sets the session keepalive and hold
intervals to the default values.
Example
The following command sequence configures the LDP session parameters: