Cisco Cisco Packet Data Interworking Function (PDIF)
PCC-Condition-Group Configuration Mode Commands
▀ an-gw-address
▄ Command Line Interface Reference, StarOS Release 16
7448
an-gw-address
This command defines a condition based on the IP address of Access Node Gateway (AN-GW) on which subscriber is
attached in an IP-CAN session.
attached in an IP-CAN session.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Condition Group
Configuration
Configuration
configure > context context_name > pcc-service service_name > condition group group_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-condition-group)#
Syntax
[ no ] an-gw-address {operator value angw_ip/mask | {in-range | !in-range} range_start_ip
to range_end_ip}
to range_end_ip}
[ no ] an-gw-address operator profile-attribute spr_attr_value
[ no ] an-gw-address operator subscription-attribute subs_prof_attr_value
no
Removes the specified condition definition.
operator
Specifies how to logically match the information in the analyzed field.
operator
must be one of the following:
!=
: Does not equal
=
: Equals
in-range
Specifies the condition to accept the IP address which are in range as argument to define the Access Node
Gateway address which is used by subscriber in IP-CAN session.
Gateway address which is used by subscriber in IP-CAN session.
!in-range
Specifies the condition to accept the IP address which are NOT in range as argument to define the Access
Node Gateway address which is used by subscriber in IP-CAN session.
Node Gateway address which is used by subscriber in IP-CAN session.
range_start_ip
Specifies the starting IP address which is used for defining the range of AN-GW IP addresses which is used
by subscriber in IP-CAN session.
by subscriber in IP-CAN session.
range_start_ip
is an IP address and must be lesser than
end_start_ip
address.