Cisco Cisco Packet Data Interworking Function (PDIF)
PCC-Condition-Group Configuration Mode Commands
▀ base-station-id
▄ Command Line Interface Reference, StarOS Release 16
7452
base-station-id
This command defines a condition based on the various parameters used in base-station id by subscriber in an IP-CAN
session between PCEF (PDSN) and IPCF over Gx interface.
session between PCEF (PDSN) and IPCF over Gx interface.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Condition Group
Configuration
Configuration
configure > context context_name > pcc-service service_name > condition group group_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-condition-group)#
Syntax
[no] base-station-id {[sid operator sys_identifier] | range start_range to end_range]]
[nid operator netwrk_identifier ] | range start_range to end_range ]] [ cellid operator
cell_identifier ] | range start_range to end_range ]]}
[nid operator netwrk_identifier ] | range start_range to end_range ]] [ cellid operator
cell_identifier ] | range start_range to end_range ]]}
no
Removes the specified condition definition.
operator
Specifies how to logically match the information in the analyzed field.
operator
must be one of the following:
!=
: Does not equal
<
: Lesser than
<=
: Lesser than or equals
=
: Equals
>
: Greater than
>=
: Greater than or equals
sid
operator
sys_identifier
Specifies the system identifier in base-station id of subscriber for condition validation in an IP-CAN session.
sys_identifier
must be an integer between 0 through 65535.
nid
operator
netwrk_identifier
Specifies the network identifier in base-station id, which is used by subscriber, for condition validation in an
IP-CAN session.
IP-CAN session.
netwrk_identifier
must be an integer between 0 through 65535.