Cisco Cisco Packet Data Interworking Function (PDIF)
Command Line Interface Reference, StarOS Release 16 ▄
7511
Chapter 238
PCC-Data-Service Configuration Mode Commands
The PCC-Data-Service Configuration Mode is used to configure the data flow parameters for the media data, as well as
corresponding attributes that are necessary for charging and policy enforcement decisions for the media parameters
represented by its service flows in the PCC-service. A maximum of ten service data flows can be configured in a PCC-
Data-Service instance.
corresponding attributes that are necessary for charging and policy enforcement decisions for the media parameters
represented by its service flows in the PCC-service. A maximum of ten service data flows can be configured in a PCC-
Data-Service instance.
Important:
This configuration mode is supported from StarOS Release 12.1 onward.
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Data Service Configuration
configure > context context_name > pcc-service service_name > data-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-data-service)#
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).